# DO NOT EDIT THIS FILE. EDIT THE MAIN.CF FILE INSTEAD. THE STUFF # HERE JUST SERVES AS AN EXAMPLE. # # This file contains example settings of Postfix configuration parameters # that control the QMQP server program. # The qmqpd_authorized_clients parameter specifies what clients are # allowed to connect to the QMQP server port. # # By default, no client is allowed to use the service. This is # because the QMQP server will relay mail to any destination. # # Specify a list of client patterns. A list pattern specifies a host # name, a domain name, an internet address, or a network/mask pattern, # where the mask specifies the number of bits in the network part. # When a pattern specifies a file name, its contents are substituted # for the file name; when a pattern is a type:name table specification, # table lookup is used instead. # # Patterns are separated by whitespace and/or commas. In order to # reverse the result, precede a non-file name pattern with an # exclamation point (!). # #qmqpd_authorized_clients = # The qmqpd_error_delay parameter specifies how long the QMQP server # will pause before sending a negative reply to the client. The # purpose is to slow down confused or malicious clients. # # By default, the QMQP server pauses for 5 seconds. # #qmqpd_error_delay = 5s # The qmqpd_timeout parameter specifies a time limit for network I/O # operations. If a read or write operation blocks for more than # $qmqpd_timeout seconds the QMQP server gives up and disconnects. # # By default, the QMQP server runs out of patience after 300 seconds. # #qmqpd_timeout = 300s