version 2.0 05-02-96 -------------------- * Switched to bfd library. Any supported format (elf, coff, ...) can be used. * The UART devices can be set through -uart1 and -uart2 switches. * Switched to GNU readline. * Added -c option to run batch files at startup * 'reg' command can show different register windows (eg 'reg w3'). * Use 'help' for online help on simulator commands version 1.8.1 20-01-96 -------------------- * added -mevrev0 switch to simulate MEC rev.0 bugs in timer and uart * added -iurev0 switch to simulate IU rev.0 jmpl/restore bug * Added sis command 'batch' to run batch files version 1.8 30-10-95 -------------------- * Added s-record support. Use the '-s' switch with sis or the 'load' command. * IU load dependencies are now modelled version 1.7 30-10-95 -------------------- * Power-down mode implemented in erc32.c. * Performance display shows the ratio between simulator-time and real-time. version 1.6.2 25-10-95 -------------------- * The UARTs can now be run at a given speed (simulator time) to better simulate the behaviour of interrupt routines. The "true mode" is selected through a compile switch in the makefile. version 1.6 28-09-95 -------------------- * Major reorganisation of the code. mec.c and mem.c merged into erc32.c. * The load command does NOT longer load the initialised data at an address defined by .bdata. This is done in srt0.s using _environ. * Additional MEC functionallity added - software reset, memory access protection and waitstate configuration register. * interf.c - a GDB interface added * -v switch (verbose) added version 1.5 14-09-95 -------------------- * Added a instruction trace buffer, enabled through the 'hist' command. * Added a 'perf' command to display statistics such as instruction mix, CPI, FPU holds etc. * Added -nfp switch to disable FPU. * Added -freq switch to set simulated frequency. version 1.4 22-08-95 -------------------- * A -g is provided for those who have problems with GNU readline(). version 1.3 26-07-95 -------------------- * No major news, just a bug fix release ... version 1.2 13-07-95 -------------------- * Added setting of IU registers through the 'reg' command. See README. * The GNU readline() function is used for command input. However, a ctrl-D still kills the simulator ... version 1.1 07-07-95 -------------------- * Added a 'go' command * Added cycle counting for interrupt overhead. * Function 'get_mem_ptr' takes one more parameter to avoid segmentation faults if a.out files are loaded outside the simulated memory. See README. * Added user-defined function sim_stop(). * Added a reset command. See README. * Implemented buffered output for MEC uarts to improve output speed.