# This is a list of toolchains that are supported on this board.
set_board_info target_install {sparclet-aout}
# Load the generic configuration for this board. This will define any
# routines needed by the tool to communicate with the board,.
load_generic_config "sparclet";
# It needs broken-saverestore by default.
process_multilib_options "-mbroken-saverestore"
# We only support newlib on this target. We assume that all multilib
# options have been specified before we get here.
set_board_info compiler "[find_gcc]"
set_board_info cflags "[newlib_include_flags] [libgloss_include_flags]"
set_board_info ldflags "-nostdlib [libgloss_link_flags] [newlib_link_flags] -Wl,-Ttext,0x12020000 -N"
# tsc701 linker script.
set_board_info ldscript "-Ttsc701.ld"
# The board doesn't return exit statuses and we need to indicate this.
# However, the standard GCC wrapper won't work with this target because
# it doesn't return stuff from printf ().
#set_board_info needs_status_wrapper 1
# The monitor uses a GDB stub.
set_board_info use_gdb_stub 1
# The GDB protocol used to communicate with this board.
set_board_info gdb_protocol "sparclet"
# The offset in memory that we load programs.
set_board_info gdb_load_offset "0x12020000"
# And the place in memory where we load the stub.
set_board_info gdb_stub_offset "0x12010000"
# No mathlib.
set_board_info mathlib "";
# We can't do I/O in GDB.
set_board_info gdb,noinferiorio 1;
# Or pass arguments.
set_board_info noargs 1;
set_board_info gcc,no_varargs 1
set_board_info gcc,no_label_values 1
# This is the old GDB prompt for the toolchain.
# Uncomment for old tests
set_board_info gdb_prompt "\\(gdb\\)";
# We always have to set a breakpoint at exit(), instead of just _exit().
set_board_info always_break_exit 1;