From: miquels@cistron-office.nl (Miquel van Smoorenburg)
Subject: Serverside IP pools design [was: Re: Questions on IP address allocation]
Date: Tue, 13 Nov 2001 13:29:24 +0000 (UTC)
Message-ID: <9sr77k$ofn$1@ncc1701.cistron.net>
To: freeradius-devel@lists.cistron.nl,freeradius-users@lists.cistron.nl
In article <DE6495F924D2304DA0FAD60FC1C00601150E3B@AVIANSERVER.aviancommunications.com>,
John Padula <john_padula@aviancommunications.com> wrote:
>I'm still looking into IP address allocation via the "+" option.
>I wanted to check if there's any sense of a lease or expiration on the
>IP address
>given out.
No, and that's not really neccesary either, since other than with
DHCP you have strictly defined session start- and stop points.
>I've checked the RFC and didn't see any mention of this, but
>wanted to
>make sure.
Because IP address allocation is completely outside the scope
of the Radius RFC / protocol.
>Coming from the DHCP world, where there's a large blob of
>processing
>devoted to lease negotiation, it seems strange that (a) we just give out
>an IP 'forever'
Not forever - until the end of the session.
>and (b) we just keep incrementing based on nas-port-id. There's no way
>to define
>a range of IPs.
That's because it really is an ugly hack.
>Is there any way to establish a hook (in the 'module' model) where
>a user could call some external function that would return an IP and
>possibly manage that IP?
It's hard but not impossible. You would have to write a routine/module
that knows about several pools (probably defined in radius.conf)
and keeps an on-disk database that accounts for the IP addresses
given out. It should look at all accounting-stop messages and mark
the IP as free at the end of a session.
There is also the problem of 'lost packets'. If an accounting-stop
packet gets lost, or if authentication fails on the NAS after you've
send an authentication ack so that start and stop packets might
not be sent at all, the IP address you allocated will not
be freed - ever. So when the pool reaches a high watermark (>90%)
then you will need to scan all sessions in the pool to see if
they are still active, using "checkrad", until you're under the
low watermark (<80%) again. High and low watermarks would presumably
be defined as part of the pool definition in radius.conf
Other ways to keep the pool clean is to also check all authentication
and accounting start packets for NAS/portno combination and if
that matches with a presumably still active pool allocation,
kill the allocation, since the original user is gone anyway.
And perhaps a time-limit - use a minimum "Session-Timeout = 86400"
for all sessions with addresses from the pool and periodically
clean up all session that are older than (86400 * 1.2) or so.
That should also be made part of the pool definition in radius.conf
ip-pool pool1 {
range-start = 192.168.10.10
range-end = 192.168.10.19
cleanup-start = 90%
cleanup-end = 80%
session-timeout = 86400
session-stale = 90000
session-db = /var/log/radius/pool1.db
}
.. or something. You get the idea.
The above is a description of how you could make serverside
IP pools possible. Now someone needs to write the code.
Mike.
--
"Only two things are infinite, the universe and human stupidity,
and I'm not sure about the former" -- Albert Einstein.