/* machine description file for Mips running RISCOS version 4. */ #include "mips.h" /* The following line tells the configuration script what sort of operating system this machine is likely to run. USUAL-OPSYS="note" NOTE-START Use -opsystem=usg5-2-2 normally, or -opsystem=bsd4-3 with the BSD world. NOTE-END */ #if 0 /* Define MIPS2 if you have an R6000 or R4000. */ #define MIPS2 #endif #ifdef __GNUC__ #define C_DEBUG_SWITCH -g -O #else /* We used to have -systype bsd43, but a configure change now takes care of that option. */ #ifdef MIPS2 #define C_DEBUG_SWITCH -DMips -g3 -Wf,-XNd4000 -O -Olimit 2000 -mips2 #else #define C_DEBUG_SWITCH -DMips -g3 -Wf,-XNd4000 -O -Olimit 2000 #endif #endif #ifdef TERMINFO #undef TERMINFO #endif #define START_FILES pre-crt0.o /lib/crt1.o /* Used to have -lisode, but jlp@math.byu.edu says remove it (for RISCOS 4.52). */ /* ethanb@ptolemy.astro.washington.edu says crtn.o uses _ctype and therefore we must search libc again after crtn.o. The -L is used to force second -lc to find the sysv version of libc.a, which is needed because the BSD libc.a doesn't have _ctype. */ #define LIB_STANDARD -lmld -lc /lib/crtn.o -L/usr/lib -lc #define COFF #undef LD_SWITCH_MACHINE #define LD_SWITCH_MACHINE -systype bsd43 -g3 -D 800000 #define NO_MODE_T /* These are needed on Riscos 4.0. It appears that's the only system which uses mips4.h and defines BSD. */ #ifdef BSD_SYSTEM #undef HAVE_STRERROR #undef HAVE_XRMSETDATABASE #undef HAVE_XSCREENRESOURCESTRING #undef HAVE_SETSID #endif